![]() ![]() Press ‘SETUP’ to display the Main screen of the SETUP Menu on the screen.The DVD player's POWER indicator turns off. To turn off the DVD player, slide the POWER ON/OFF to OFF.Rotate the BRIGHTNESS and VOLUME controls to adjust the picture brightness and the DVD player’s volume.The unit will load the disc and start playing. Close the tray by pressing “PRESS” button.Open the disc tray by pressing OPEN, place a disc into the tray with label side of disc facing up.After connecting power to the unit, power on” DVD player” with the power switch.Adjust the straps tightly so that the bag is secured.In some vehicles, it may be necessary to attach the “S” connector to the rail directly, as it may not be long enough to reach back to the ring. Attach the “S” hook to the same ring after looping the strap around the seat rail. Take another strap from the carrier bag, and connect the latch to the lower metal ring on the left side of the bag.Adjust the strap until the bag is firmly secured. Connect the “S” hook to the other upper metal ring and place the loop over the headrest. Connect the latch to one of the upper metal rings on the mounting bag. Take one of the supplied straps from the carrier bag.Installing The System Onto Vehicle Seat Back: Using the DC Adapter: To use the supplied Vehicle DC Adapter, disconnect the Battery pack and connect the Vehicle Power Plug Adapter into the DVD Player’s Power Jack and the other end into the Vehicle DC outlet (Cigarette Lighter Socket). Carefully remove the Battery Pack from your player.Remove the Battery Pack by gently sliding it towards the side of the unit.Press and hold the Battery Release Tab (located on the bottom) in the direction of the arrow.Place the player on a soft and smooth surface with the bottom of the unit facing up.Make sure the power is turned OFF before detaching the Battery Pack. This will eventually discharge the battery. When the DVD Player is turned OFF, the DVD Player is still consuming some power in STANDBY mode. Plug the other end of the AC Power Adapter Cord into a household AC Outlet.ĭetaching the Battery Pack: If the DVD Player is not going to be used for long periods of time, the battery pack should first be fully charged and the Battery Pack should be detached.Plug the supplied AC Power Adapter into the player’s power jack marked with ”DC+12V IN”, which is located on right side of the DVD Player.Attach the battery pack to the DVD player. ![]() Slide the Battery Pack until you hear it click and lock into place.Ĭharging the Battery Pack: The battery pack must be attached to the DVD player to charge it using the supplied AC Power Adapter.With one hand on the DVD Player to prevent it from moving, take the battery and align the four plastic tabs on the battery pack with holes on the player, and push the battery pack into the DVD Player.Place the DVD Player on a soft and smooth surface with the bottom of the unit facing UP.If the battery will not be used for a long period of time, fully charge the battery prior to storage. A fully charged battery delivers about 2-1/2 to 3 hours of use, but playing time varies from disc to disc. Charge the battery fully before initial use. Rechargeable Battery Pack: Your portable DVD player comes with a lithium ion rechargeable battery that attaches to the rear of the DVD player.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |